OEM

"You want to make your cameras or video servers smarter ?"

"Your product supports 8 or 16 channels, but only very few with video analytics ?"

"You need hundreds of IV channels but you don't want to built up a whole data center ?"

Embedding viasys algorithms into your product is easier, cheaper and faster than you think:

viasys analytics can be embedded everywhere

viasys analytics can be integrated in almost anything that runs a CPU:

1. in all edge devices (cameras, video encoder / streamers, network devices like hubs and switches)
2. centralized  platforms (hardware/software) such as DVRs, VMS, or any server.

Only minimal resources needed to embed viasys

The viasys algorithm is by far the fastest and smartest analytical solution available in the industry. Only some hundred Kbyte of flash memory and the same amount of of RAM is required to run the full featured analytics. CPU usage is usually lower than the CPU load of primitive “pixel counting” motion detection.

All operating systems are supported

viasys will run on any operating system that is able to execute and compile programs written in the language "C". For sure it will run under Linux and Windows.

No initial cost, no upfront fees

viasys will not charge any development costs for the integration into OEM partners hardware. Each party covers his own cost and has only to invest some manpower into that integration.

A short integration process to create a prototype

Only 1 to 3 months and in general only some man-day’s of development support from the OEM partners side: The integration is not very complicated in most cases and via:sys has already good experience in embedding its solution (e.g. Axis, IQeye, …).

Integration of viasys into 3rd party OEM products in 5 easy steps

ToDo’s from OEM partner		ToDo’s from viasys
1.) Providing of information about hardware / software system where viasys edge analytics should be integrated. 3.) Installation of a Software Development Kit (SDK) on a viasys server so that the viasys core algorithm can be compiled. 5.) Integration and first test of viasys analytics on partners device / system		2.) Check from viasys if partner system is ok for viasys edge analytics 4.) Adaption of the core libraries to the CPU, operating system and special needs of the OEM partners target system. Compiling of a core library or even an executable for partners.
From that moment viasys edge analytics already runs on the OEM-partners system. First performance and stability tests can be done.

viasys software plug-in gives system integrators and OEM technology partners a new level of flexibility to deploy this solution to existing edge devices without any hardware upgrades.

Dirk Owerfeldt, Co-Founder and VP